Napoleon-grills PRESTIGE II 308 User Manual download pdf (Page 8)

CLEANING THE OUTSIDE OF THE GAS GRILL - Do not use abrasive cleaners to clean any painted, porcelain or stainless

steel parts. Porcelain enamel components must be handled with additional care. The baked on enamel finish is glass like, and

will chip if struck. Touch-up enamel is available from your Napoleon Gas Grill dealer. Exterior grill surfaces should be cleaned

while warm to the touch, with warm soapy water. To clean stainless surfaces, use a stainless steel cleaner or a non-abrasive

cleaner. Always wipe in the direction of the grain. Do not use steel wool, as it will scratch the finish. Stainless steel parts will

discolour when heated, usually to a golden or brown colour. This discolouration is normal and will not affect the performance of

the grill.

MAINTENANCE INSTRUCTIONS

DARK BLUE

LIGHT BLUE

BURNER

BURNER PORT

Turn off the gas at the source and disconnect unit before servicing. Maintenance should only be done when the grill is

cool, to avoid the possibility of burns. A leak test must be performed annually, and whenever any component of the gas

train is replaced.

COMBUSTION AIR ADJUSTMENT - (This must be done by a qualified gas installer.) The air shutter is factory set and

should not have to be adjusted under normal conditions. However, some extreme field conditions may exist that require

adjustment. When the air shutter is adjusted correctly, the flames will be dark blue with light blue tips, and occasional yellow tips.

YELLOW TIPPING

If the burner is getting too little air, the flames will be lazy yellow, and possibly produce soot. If the burner is getting too much

air, the flames will be lifting erratically from the burner and may cause difficulties when lighting.

1. To adjust the air shutter, remove cooking grids and sear plates and leave lid open. The back cover must be removed for

back burner air shutter adjustment.

2. Loosen air-shutter lock screw and open or close air shutter as required. The normal settings are:

Main Burner Propane 1/4" Back Burner Propane Full Open

Natural 1/8" Natural 3/8"

3. Light burners and set to high. Visually inspect burner flames. When shutters are set, turn burners off, tighten locking screw,

and replace removed parts. Ensure that the insect screens are installed.

HOSE - Check for abrasion, melting, cuts and cracks. If any of these conditions exist, do not use gas grill. Have part replaced

by your Napoleon Gas Grill dealer, or qualified gas installer.

APPROXIMATELY

1/2"

It is recommended that this gas grill be thoroughly inspected and serviced annually by a

qualified service person.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

Napoleon-grills PRESTIGE II 308 User Manual Page 8